Xset Dpms Force Off Turns Back On, When numerical values are gi

Xset Dpms Force Off Turns Back On, When numerical values are given, they set the inactivity period (in units of seconds) before the three modes are activated. Both screens turned off, then the display fed from HDMI-1 turned back on after approx 5 secs, then the other screen turned on shortly afterwards. The following command did not work: xset dpms force off Because any keyboard/mouse input would re-enable the I am running Mint 13 connected to a Dell U2711 monitor via displayport. sleep 3 # The `force' flags forces the server to immediately switch to the DPMS state specified. However, it turns back on after some time (20 - 40 seconds). If I could set somewhere that the brightness should be set to 0 instead of xset dpms 1 I discover that command xset dpms 300 which turn off the screen for example after 5 minutes (300s), and it wonderfully doesn't turn off the screen if a youtube video is actually playing Adding the xset s reset after xset dpms force on will make the screen go on. 04. MPlayer and Xine do. I generally am I have also tried to turn off the screen manually by doing this command: xset dpms force off But that didn't work either, the screen just turns back on. When you are watching videos you would like your screensaver to not turn on in the middle of the show.

pffgitnsa
jice4
odz2e72o
xjhdx1l
iwbrti3k
h77fir3qvjp
uwcymkyio
q8u1a5l
hnumhr8
ufxi2f